|In order to prevent potential leakage issue from happening due to inappropriate handling, please comply with rules and notice below to avoid occurring water-in incident.
1.Please make sure the waterproof cover (no matter hard or soft material) is exactly mounted after changing low or high beam to maintain the waterproof foam/seal is tight.
2.Please confirm the bulb holder is exactly installed with an appropriate seal after changing turn signal bulb.
3.Please make sure the adjusting screw rod is properly mounted with an appropriate seal after assembling the rod.
4.Prohibit using abnormal bulb type to prevent waterproof failure from occurrence because of loose seal.
5.Please confirm the motor is properly mounted with an appropriate seal after assembling the motor.